LifeWave icewave Mode D'emploi page 2

INSTRUCTIONS FOR USE
BEAD INSTRUCTIONS
Place one white and one tan patch on the body, using
one of the locations shown. Apply the patches to clean,
dry, undamaged skin. Patches may be worn for up to
12 hours before discarding. Remove the liner from the
adhesive backing using the medical grade adhesive
side of the patch to secure patch placement. Only
remove half of the patch backing until an effective
placement site has been located.
Warnings: Remove immediately if you feel discomfort or skin irritation
occurs. Do not reuse patch once removed from the skin. For external use
only. Do not ingest. Do not use on wounds or damaged skin. Ask a health
professional before using if you have a health condition, any questions or
concerns about your health. Do not use if pregnant or nursing. This booklet
is no way intended to be medical advice. Individual results will vary.
STEP 1
First, locate the acupressure point
you wish to stimulate.
STEP 2
Next, remove a plastic bead from
the bag. Remove the backing from
the adhesive plastic patch included.
Place the plastic bead in the center
of the patch on the adhesive side of
the patch.
STEP 3
Lastly, apply the bead and patch to
the acupressure point, smoothing
the patch on so that it is properly
secured to the skin. There should be
a mild pressure on the acupressure
point.