Key To Symbols; Symbols On The Machine - Husqvarna FS400 LV Mode D'emploi

Symbols on the machine:

WARNING! The machine can be a dangerous
tool if used incorrectly or carelessly, which can
cause serious or fatal injury to the operator or
others.
Please read the operator's manual carefully
and make sure you understand the instructions
before using the machine.
Wear personal protective equipment. See
instructions under the "Personal protective
equipment" heading.
All displacement of the machine outside the
cutting area shall be carried out with the tool
not in rotation.
Remove the blade prior to hoisting, loading,
unloading and transporting the machine.
Arrow on tool guard indicating
the direction of tool rotation.
Up and down plunging
The guards should always be fitted on the
machine. Never allow blade exposure to
exceed 180°.
Check the cutting attachment. Never use blunt,
cracked or damaged equipment.
The blades should be marked with the same or
a higher speed than that stated on the
machine's rating plate. A cutting blade running
at a too high speed can break or cause serious
damage.
Do not use the machine near ignitable
substances or gases.
WARNING! Dust forms when cutting, this can
cause injuries if inhaled. Use an approved
breathing mask. Avoid inhaling exhaust fumes.
Always provide for good ventilation.
Hot surface.
Machinery hazard! Always keep all parts of
your body away from blade and all other
moving parts.
Risk of cutting. Keep all parts of your body
away from the cutting equipment.
2 –
English

KEY TO SYMBOLS

Transmission stop
Parking brake Activated /
Deactivated
Cutting depth indicator
Fill tank only with water
Keep saw leveled, without blade, when
checking oil level.
Always use the machine mounted lifting eye
when lifting.
This product is in accordance with applicable
EC directives. If marked on the machine.
Noise emission to the environment according
to the European Community's Directive. The
machine's emission is specified in the
Technical data chapter and on the label.
FS400 LV
Type plate
A: Brand
B:
Manufacturer,
address
C: Type
D:
Manufacturing
date, year,
week Serial number
E: Product number
F: Weight
G: Blade size - max, mm
H: Speed, blade, rpm
I: Power input max (kW)
Other symbols/decals on the mac hine refer to special
certification requirements for certain markets.
N
P
0
300 (12")
350 (14")
400 (16")
450 (18")
Fill Tank Only with
water!
DO NOT fill tank
With Gasoline Or
Flammable Liquids!
Injury Or Death Could
Occur!
LV LV
B
A
C
E
D
I
F
G
H