Publicité
Les langues disponibles
Les langues disponibles
1.
PLEASE BEWARE THAT...
In order to prevent the risk of accident, a correct installation must be done following the instructions of this
manual. Your ECOFOREST distributor will be available to help you and provide you information related to codes,
assembly and installation norms in your area.
As ecoforest do not have direct control on the installation of your stove, ecoforest do not guarantee it and do
not bear the responsibility of any damage that could result from a bad use or a bad installation.
We carefully recommend the heat calculation to be made by a qualified heating engineer.
We recommend that a confirmed specialist sets up your pellets stove.
Maintenance work to be carried out at the end of the season or for every 500 kg of fuel burned, as well as
any repairs or equipment modifications, must be performed by authorized personnel.
Before getting started with the stove installation, please check section 4.
2.
ADVICE AND RECOMMENDATIONS.
2.1.
All local regulations, including those referring to national and European standards must be met when
installing the boiler.
2.2.
The stove must be installed on floors of sufficient bearing capacity and, if the existing construction does not
allow this, the floor must be adapted and made suitable, for example by fitting a load distribution plate.
2.3.
Never use petrol, fuel for lanterns, kerosene nor any similar liquid. Keep this kind of fuel away from your
stove.
2.3.
Do not try to turn on your stove if some glass is broken.
2.5.
Make sure the glass door of the fireplace is well closed while the boiler is in operation; also check the
cleaning hatches (if you have touched them).
2.6.
Unauthorized modifications are forbidden. Use only spare parts provided by Ecoforest (see exploded view).
2.7.
Do not overload the stove; continuous heating efforts might cause premature aging and damage paint (it is
recommended not to exceed 250°C for gas outlet temperature).
2.8.
Do not use the stove as a burner.
2.9.
To prevent possible electrical shocks, only trained personnel should have access to the sides and the back of
the stove.
2.10. For the Keops stove model, the air-convection trim cover must be open whenever the stove is operational.
Air-convection trim cover.
2.11. In order to refill the stove with fuel, the user must open the hopper lid and empty the contents of the fuel
tank carefully, to prevent it from overflowing.
Moon, Mónaco, Keops and Lyon (drawing 3) models: Activate the closures to open the lid and ensure that the
lid is correctly closed after the hopper has been loaded.
In airtight installations, do not open the hopper during operation of the machine.
26
Drawing 1
Publicité
