Lelit William PL72 Mode D'emploi page 13

Note.
If the coffee flow in your espresso machine is very slow, the coffee grinding is
too fine, if it's quick, the coffee grinding is too coarse. Many factors influence the coffee flow
such as: the amount of coffee, its pressing, the espresso machine adjustments, how clean the
filters are and also the climatic conditions.
H
Adjust the doses
Note.
The grinder is fitted with the LCC (Lelit control center), which allows to
program the grinding time for both doses.
Note.
The factory pre-set parameters are 3,0 seconds for 1 dose and 5,5 seconds for
2 doses. The grinding time can vary from 2 seconds to 20 seconds.
H.1 To enter in the programming mode and change the grinding time for 1 dose,
press once the "-" button, the display shows the icon and the time (3,0") for 1 dose.
H.2 To enter in the programming mode and change the grinding time for 2 doses,
press twice the "-" button, the display shows the icon and the time (5,5") for 2 doses.
H.3 Press the "+" button to access, and then press the "-" or "+" button to de-
crease or increase the grinding time.
H.4 Three seconds after the last press of a button, LCC stores the data and exits
from settings mode.
I
Reset the parameters
I.1 To reset the electronic card, turn the grinder off. Once off, keep the "+" button
of the LCC pressed, and then turn on the grinder by pressing the switch (5), the
"Preset done" message will appear on the LCC display to confirm that the reset
has been completed. Turn off and turn on the grinder by pressing the switch (5).
J
Energy saving
J.1 When the grinder has not been used for 30 minutes, it goes in stand-by, the
LCC display turns off and the led light (6) blinks every 3 seconds.
J2. To turn it back on, press the button (7) (PUSH) or the button (4) (adding coffee).
Note.
To disable the stand-by function, turn the grinder off, by pressing the switch (5).
Keep the button (4) (adding coffee) pressed and turn the grinder back on by pressing the
switch (5), the led light (6) will remain off. Turn off and turn on the grinder by pressing the
switch (5).
Note.
Every time the grinder is turned on, if the stand by function is disabled, the led
Lelit Espresso - English
EN
13