Ip Alarm Module; Live View; Warning; User - Abus TVHD80000 Manuel Utilisateur

Configuration

IP Alarm Module

You can add ABUS IP alarm modules (CASA10010)
here. After successfully connecting via the network, two
alarm inputs and two alarm outputs are added to each of
the "Alarm Input" and "Alarm Output" tabs. The short
name of the inputs is
U1<-1 / U1<-2, whilst the short name of the outputs is
U1->1 / U1->2.
Click on "Add" to configure an ABUS IP alarm module.
Parameter Setting
IP Alarm Modu- A unique name for the IP alarm mod-
le ule can be entered here.
IP Address Enter the IP address of the IP alarm
module here.
Manage Port Enter the port (default: 8000) of the IP
alarm module here.
Admin Name Enter the user name of the IP alarm
module here (user must have admin-
istrator rights).
Password Enter the password of the user speci-
fied above here.
After a successful connection two virtual alarm in- and
outputs are added. These can only be switch by network.
Note
Please refer to the homepage (www.abus-sc.com)
to find further installation instructions in the down-
load section of the ABUS IP Alarm Module
(CASA10010).
RS-232
Currently no functioning.

Live view

See page 84.

Warning

Note
Enter the trigger under "Exception Type", for ex-
ample:

HDD Full

Disconnected
After doing this, specify the device behaviour as
detailed on page 38.
Confirm the settings by clicking Apply and leave the
menu with Back.

User

Warning
Note down the admin password.
The following password is preset
110