Recording; Setting Up; Schedule - Abus TVHD80000 Manuel Utilisateur

Masquer les pouces Voir aussi pour TVHD80000:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 185

Recording

Recording

Setting up

Open the main menu and click on record:

Schedule

The schedule is used to specify the recording times and
triggers (recording type) for the cameras. Click on the
"Schedule" tab:
Note
Because there is no difference between the set-
tings for the TABs record and instant image, these
are only listed once.
In the OSD, the hours of the respective days are listed
from left to right (the days are listed from top to bottom).
A colour key is shown underneath the days (i.e. the re-
cording periods in the schedule are shown in colour ac-
cording to the trigger (recording types)).
Colour symbol
Key
Blue
Normal recording: Period in hours
Yellow
Motion detection
Light blue
Motion detection and alarm
Red
Alarm
Grey
No selection
Brown
Motion or alarm
the
Select 
 camera and click on the check box Enable 
Schedule. 
Click on Edit to specify the type and duration of the 
time plan 
97
1. Define the day to be set in the pull-down menu at
'Schedule'.
2. Activate/deactivate 'All day'. If the full day is active, no
definite times can be entered as the setting is now
valid for the whole day.
3. To make specific time settings, deactivate the "All
Day" box.
Application example
Recording should run from 11:00 to 07:00. 2 time
zones must be set up for this:
1. 11:00 AM - 24:00PM
2. 00:00 AM - 7:00 AM
4. Specify the recording type in the drop-down menu:
Time
Motion detection
Alarm
Motion detection or alarm
Motion detection and alarm
Note
To record using motion detection or the alarm, you
must first set this up in the Camera menu (see p.
39"Setting up of zones") or Configuration (see p.
48 "Alarm").
5. When making a specific time setting, you can define
up to 8 time periods (each from 00:00 to 24:00). The
times in the individual periods must not overlap.
Note
The "Time" recording type defines the time win-
dow where a recording is made.
The other events (e.g. motion detection and/or
alarm) only trigger the recording after the specific
event has occurred.

Publicité

Table des Matières
loading

Table des Matières