Table des Matières
Publicité
2 Connecting Up
Home theater video connections
Important: Before making or changing any rear panel connec-
tions, make sure that all components are switched off and unplugged
from the wall outlet.
This player outputs video in a number of different ways. Choose the
one most suitable for your system using the guide below.
1
If your TV has a SCART input, we recommend using it
to connect directly to the
on this player.
4
See Setting the TV System switch and Setting the
component video switch below.
Connecting SCART and S-Video cables
SCART and S-Video cables will only plug in one way, so make sure the
plug is correctly lined up with the jack before inserting. Be sure to
fully insert for a good connection.
Note: The AV1(RGB)-TV connector can output composite, S-
Video or RGB component video; the AV2 SCART connector only
outputs composite video. If you connect just one TV, use the AV1
(RGB)-TV connector. You can select the type of video output by
changing the Video Out setting in the Setup Menu.
S-Video or composite video?
S-Video should give a better picture, so if you have an S-Video input,
use it. S-Video cables are available from any good audio/visual dealer.
Setting the TV System switch
Set the
switch to match the TV system in your country
TV SYSTEM
or region. If you have a multi-system TV that can display both PAL
and NTSC signals, set this switch to
watch both PAL and NTSC Video CDs and DVD discs.
This system can convert NTSC to PAL, so setting this switch to
will enable you to watch any PAL or NTSC disc.
22
En / Fr
or
output
AV1(RGB)-TV
AV2
AV CONNECTOR
525i
525p
AV1(RGB)
(480i)
(480p)
-TV
MENU
SELECT
COMPONENT VIDEO OUT
AV2
R
CONTROL
DIGITAL OUT
TV SYSTEM
2
OUT
IN
NTSC
PAL
AUTO
1
OPT
COAX
. This will allow you to
AUTO
2
If your TV/monitor has component video inputs instead of a SCART
input, connect them to the
this player.
Y
P
P
B
R
1
2
1
S-VIDEO OUT
VIDEO OUT
AUDIO OUT
L
2
1
3
If neither SCART nor component inputs are available to you,
connect this player to your TV or AV receiver using either the
or
VIDEO OUT
S-VIDEO OUT
This system can also convert PAL to NTSC, but only for Video CDs, so
setting this switch to
Setting the component video switch
You only need to set this switch if you're using an NTSC TV/
monitor connected via the component video outputs of this player.
This player can output NTSC video as a standard interlaced signal
(the 525i(480i) setting), or as a non-interlaced, or progressive
scan signal (the 525p(480p) setting). Generally, however, you
should leave it set to
from the on-screen Setup menu. Switch manually if you have chosen
a setting from the Setup menu that is incompatible with your
television/monitor and therefore can't see any picture.
PAL
COMPONENT VIDEO OUT
2
AC IN
jacks.
will limit you to NTSC DVD discs.
NTSC
, which makes this setting switchable
MENU
jacks on
Publicité
Table des Matières
