Adjusting The Position Carrier Base; Changing The Trigger Travel; Increase The Trigger Pull Weight - Hämmerli LUFTPISTOLE AP20 Mode D'emploi

AP20
Air Pistol

5.5.2 Adjusting the position carrier base

The trigger carrier must be removed before adjusting the carrier (see Chapter 5.5.1).
• Completely screw the setscrew (a) out of the carrier base.
• Loosen the setscrew (b) with the SW2 hexagonal screwdriver and press the carrier base on the
horizontal mounting pin into the desired position and rotate the carrier base to the right or left if
necessary.
• Tighten the setscrew.
• Adjusting the trigger carrier (see Chapter 5.5.1).

5.5.3 Changing the trigger travel

The slack between the resting position of the trigger carrier and the pressure point position can be
regulated using the adjusting screw (c).
• Shorten the trigger travel: Turn the adjusting screw clockwise.
• Lengthen the trigger travel: Turn the adjusting screw counter clockwise.

5.5.4 Increase the trigger pull weight

The trigger pull weight is the sum of the trigger weight and pressure point weight.
In order to increase the trigger pull weight, the first stage trigger weight and / or the pressure point
weight can be increased.
• Increasing the first stage trigger weight:
Screw in the setscrew (d) clockwise using the SW2 hexagonal screwdriver. The first stage trig-
ger weight will increase.
• Increasing the pressure point weight:
WARNING Changes to the factory settings of the pressure point weight, trigger stop and
pawl intersection can lead to damages and inability of the pistol to function.
Furthermore, the light touch of the trigger, shaking or other handling pose the
risk of unintended firing.
fDo not make changes to the settings in the absence of extensive and rele- f
vant experience and knowledge (experts, gunsmiths, experienced shooters).
fAttach the compressed air tank.
f
Screw in the setscrew (g) clockwise using the SW2 hexagonal screwdriver. The pressure point
weight will increase.
24