Adjusting The Trigger Carrier - Hämmerli LUFTPISTOLE AP20 Mode D'emploi

1
3
c
1 Mounting pin for carrier base
2 Trigger carrier
3 Carrier base
4 Positioning holes trigger carrier
a Setscrew trigger carrier fastening
b Setscrew trigger carrier base fastening

5.5.1 Adjusting the trigger carrier

The trigger carrier (2) setting can be horizontally and vertically adjusted to each unique trigger finger.
There are two positions (4) available on the carrier base (3) for adjusting the height.
Changing the height of the trigger carrier on the carrier base:
• Loosen the setscrew (a) using the SW2 hexagonal screwdriver.
• Remove the trigger carrier from the current positioning hole and insert into the other positioning
hole.
• Tighten the setscrew (a).
NoTE If the trigger carrier was mounted onto the lower position of the carrier base,
screw the setscrew (a) into the carrier base until the trigger carrier can be fas-
tened in the upper position.
If the trigger carrier was mounted onto the upper position of the carrier base,
screw the setscrew (a) out of the carrier base until the trigger carrier can be
fastened in the lower position.
Twist and press the trigger carrier onto the carrier base
• Loosen the setscrew (a).
• Move the trigger carrier to the front or back or turn it along its horizontal axis to the desired
position.
• Tighten the setscrew (a).
b
2
c Adjusting screw trigger travel
d Adjusting screw trigger weight
e Adjusting screw pawl intersection
f Adjusting screw trigger stop
g Adjusting screw pressure point weight
23
d
4
a
DE
EN
e
ES
f
g FR