Adjusting The Sight; Adjusting The Integral Front Sight - Hämmerli LUFTPISTOLE AP20 Mode D'emploi

AP20
Air Pistol

5.3 ADjuSTING THE SIGHT

Setting the sight and sight length depends on the anatomy and ability of the shooter. The ideal posi-
tions of the rear and front sights must be determined by testing and individually adjusting.
The optimal width of the front sight should typically match the width of the «black in the target»
when aiming.
WARNING Adjustment of the sight poses the risk of unintended firing.
fEnsure that the pistol is unloaded and uncocked when making adjustments. f

5.3.1 Adjusting the integral front sight

The integral front sight has three sight widths (4 mm, 4.5 mm, 4.9 mm) and is fastened in the compen-
sator with a standard setscrew. The notches on the base of the front sight guarantee an exact setting.
1 Compensator
2 Three-stage integral front sight
• Loosen the setscrew (3) on the compensator (1) using the hexagonal screwdriver (4).
• Remove the front sight (2), adjust the width of the front sight and reinsert.
• Tighten the setscrew.
1 2 3 4
3 Setscrew
4 SW2 hexagonal screwdriver
18