Reconfiguring The Pressure Reducer; Empty Any Remaining Air From The Pistol's Pressure Reducer; Reconfigure The Pressure Reducer - Hämmerli LUFTPISTOLE AP20 Mode D'emploi

5.4 RECoNFIGuRING THE PRESSuRE REDuCER

5.4.1 Empty any remaining air from the pistol's pressure reducer.

When the compressed air tank is removed from the pistol, air can only slowly escape.
• To empty the pressure reducer, cock but do not load the pistol and fire in a safe direction.
• Repeat this emptying process 2-3 times.

5.4.2 Reconfigure the pressure reducer

The pressure reducer is mounted in the downward position in the factory with connection pieces for
the compressed air tank. The pressure reducer must be reconfigured for the compressed air tank to
be mounted parallel to the barrel.
After configuration, a trigger guard, which is available as an accessory, can be mounted on the pres-
sure reducer (see Chapter 10).
1
2
1 Pressure reducer (factory settings)
2 Connection pieces (compressed air tank)
CAuTIoN
An O-ring serving as a seal is fitted to the pressure reducer thus creating a
compressed air connection to the system housing.
Damage to the O-rings and defilement of the mounting surfaces can lead to
malfunctions.
fInspect the O-ring for damage and replace if necessary. f
fKeep the mounting surfaces clean. f
• Loosen and unscrew the fastening screw (3).
• Remove the pressure reducer (1).
• Inspect the O-ring for damage and replace if necessary.
• Inspect the mounting surfaces for defilement and clean if necessary.
• Attach the pressure reducer with the connection pieces (2) pointing toward the barrel.
• Screw in and tighten the fastening screws.
• Screw the filled compressed air tank to the pressure reducer hand-tight.
3 3
3 3
3 Fastening screw
4 Pressure reducer (user settings)
21
DE
EN
ES
FR
4
2