Publicité
Les langues disponibles
Les langues disponibles
WARNING:
exhaust system become very hot during
operation. Risk of burn injury. Let the
engine and the exhaust system become
cool before you fill fuel in the product.
WARNING:
tank as a support area.
CAUTION:
result in engine damage.
The engine runs on gasoline with a minimum octane
rating of 91 RON (87 AKI), not mixed with oil. We
recommend biodegradable alkylate gasoline.
•
Do a check of the fuel level before each use and
refuel if it is necessary.
•
Do not fill the fuel tank fully. Fill to the bottom of
the fuel tank neck.
To adjust the seat
The position of the seat can be moved forward or
rearward and suspension of the seat can be
adjusted.
WARNING:
adjustments to the seat when the
product is in operation.
•
Turn the knob below the seat (A) to adjust the
seat suspension. Turn the knob counterclockwise
for soft suspension and clockwise for hard
suspension.
•
Push the lever below the seat (B) to the side and
push the seat forward or rearward.
To fold the seat
The seat can be folded forward to get access to the
battery and hydrostatic transmission system.
1. Park the product on level ground.
12
The engine and the
Do not use the fuel
Incorrect type of fuel can
Do not make
A
B
2. Push the lever and push the backrest of the seat
forward to fold the seat forward.
To engage and disengage the
parking brake
This product has no dedicated parking brake lever.
The parking brake is integrated in the 2 control
levers.
•
Push the 2 control levers away from the seat at
the same time to engage the parking brake.
Product overview on page 3 for the
Refer to
location of the control levers.
Note:
The product must be stationary when
you engage the parking brake.
Note:
The engine will stop if you do not push
the 2 control levers away from the seat at the
same time.
•
Pull the 2 control levers in the direction of the
seat to disengage the parking brake.
To disengage and engage the drive
system
CAUTION:
engage the drive system when the
product is parked on level ground.
If it is necessary to move the product by hand, with
the engine off, the drive system must be disengaged.
The drive system is disengaged and engaged by the
bypass valves. The bypass valves are found on the
front of each transmission.
Follow the procedure below to disengage the drive
system.
1. Park the product on level ground and stop the
engine.
2. Set the cutting deck to the lowest position.
3. Set the control levers in neutral position.
4. Lift the seat.
Only disengage or
1741 - 001 - 08.11.2021
Publicité
