DRILL DOCTOR 500X Mode D'emploi page 5

get caught in moving parts. Nonslip footwear is recommend-
ed. Wear protective hair covering to contain long hair.
• ALWAYS USE SAFETY GLASSES. Also use face or dust
mask if cutting operation is dusty. Everyday eyeglasses
only have impact resistant lenses, they are NOT safety
glasses.
• USE EAR PROTECTION DURING USE. The Drill Doc-
tor ® can generate up to 91 dB [A] and 90 dB [C] noise
emissions when in operation. The Drill Doctor
erate up to 17.0 m/s
• SECURE WORK. Use clamps or a vise to hold work when
practical. It's safer than using your hand and it frees both
hands to operate tool.
• DO NOT OVERREACH. Keep proper footing and balance
at all times.
• MAINTAIN TOOLS WITH CARE. Keep the Drill Doc-
® clean for best and safest performance. Follow
tor
instructions for maintenance and changing accessories.
Inspect cords periodically and if damaged have them
repaired by an authorized service facility. Inspect exten-
sion cords periodically and replace if damaged. Keep unit
dry, clean and free from oil and grease.
• DISCONNECT TOOLS before servicing. Always discon-
nect the Drill Doctor
changing accessories, such as the diamond sharpening
wheel. When not in use, disconnect from the power sup-
ply. Never touch internal parts of the sharpener when it is
turned on or plugged in. The rotating diamond wheel can
cause injury.
• REDUCE RISK OF UNINTENTIONAL STARTING. Make
sure switch is in the "OFF" position before plugging in.
• REMOVE ADJUSTING KEYS AND WRENCHES. Form
habit of checking to see that keys and adjusting wrenches
are removed from tool before turning it on.
• USE RECOMMENDED ACCESSORIES. Consult this man-
ual for recommended accessories. The use of improper
accessories may cause risk of injury to persons.
• NEVER STAND ON TOOL. Serious injury could occur if
the tool is tipped or if the cutting tool is unintentionally
contacted.
• CHECK DAMAGED PARTS. Before further use of the
www.drilldoctor.com
2
[RMS] vibration when in operation.
when cleaning, inspecting, and
®
® can gen-
3