DRILL DOCTOR 500X Mode D'emploi page 15

1.
2.
Alignment Button
118°
Drill Bit
Stop
start the alignment in the closest setting to the point angle
desired. (For example, if you are setting the point angle
below 118°, then set the alignment in the 118° setting.)
Refer to "Using the Variable Alignment to Adjust the Chis-
el and Relief Angle" on page 23.
www.drilldoctor.com
Insert bit in Chuck and
tighten
Insert the bit into the Chuck
Jaws and close the Jaws just to
the point where the bit slides in
and out. Do not over tighten
the Chuck; the bit needs to be
able to move in and out until
Step 4. (Model 750X users
refer to "Using the Variable
1"
Material Take-Off (MTO)" on
page 24.)
A good test to see if the Chuck
is tightened the correct amount
is to make sure it moves when
you pull on it with your fingers,
but will not fall out when you
turn the Chuck upside down.
Alignment
Guide
Insert Chuck into
Alignment Port
Press the Alignment
Button down and hold it.
Match either of the
Alignment Guides on the
Chuck with the 118°
Notch on the Alignment
Port. Insert the Chuck.
While holding the button
down, slide the drill bit
forward until it touches
the Drill Stop and the
Chuck is pushed all the
way into the Alignment
Port. Release the Align-
ment Button.
If you are using a Model
750X and have chosen
a custom
(between 115° and 140°),
bit point
13