Makita HR2800 Manuel D'instructions page 5

ENGLISH
1. Switch trigger
2. Lamp
3. Reversing switch lever
4. Quick change chuck for SDS-plus
5. Change cover line
6. Change cover
7. Spindle
8. Quick change drill chuck
SPECIFICATIONS
Concrete
Capacities
No load speed (min
Blows per minute
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
For Model HR2800
Intended use
The tool is intended for hammer drilling and drilling in
brick, concrete and stone.
It is also suitable for drilling without impact in wood, metal,
ceramic and plastic.
For Model HR2810, HR2810T, HR2811F, HR2811FT
Intended use
The tool is intended for hammer drilling and drilling in
brick, concrete and stone as well as for chiselling work. It
is also suitable for drilling without impact in wood, metal,
ceramic and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
ROTARY HAMMER SAFETY
WARNINGS
DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to safety
rules for the subject product. If you use this tool
Explanation of general view
9. Action mode changing knob
10. Grip base
11. Side grip
12. Teeth
13. Protrusion
14. Bit shank
15. Bit grease
16. Bit
Model
Tungsten-carbide tipped bit
Core bit
Diamond core bit (dry type)
Steel
Wood
-1
)
Overall length
Net weight
Safety class
HR2800/
HR2810
314 mm
3.4 kg
unsafely or incorrectly, you can suffer serious
personal injury.
ENE042-1
1. Wear ear protectors. Exposure to noise can cause
hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
3. Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
ENE043-1
accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live" and
could give the operator an electric shock.
4. Wear a hard hat (safety helmet), safety glasses
and/or face shield. Ordinary eye or sun glasses
ENF002-1
are NOT safety glasses. It is also highly
recommended that you wear a dust mask and
thickly padded gloves.
5. Be sure the bit is secured in place before
operation.
6. Under normal operation, the tool is designed to
produce vibration. The screws can come loose
easily, causing a breakdown or accident. Check
tightness of screws carefully before operation.
7. In cold weather or when the tool has not been
GEB007-6
used for a long time, let the tool warm up for a
while by operating it under no load. This will
loosen up the lubrication. Without proper warm-
up, hammering operation is difficult.
17. Chuck cover
18. Depth gauge
19. Dust cup
20. Blow-out bulb
21. Chuck adapter
22. Keyless drill chuck
23. Sleeve
24. Ring
HR2810T HR2811F
28 mm
80 mm
80 mm
13 mm
32 mm
0 - 1,100
0 - 4,500
339 mm 320 mm
3.5 kg 3.5 kg
/II
HR2811FT
345 mm
3.6 kg
5