Makita TD0100 Manuel D'instruction page 5

2
1
009617
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
If the bit is not inserted deep enough into the
•
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this case,
try re-inserting the bit according to the instructions
above.
OPERATION
009618
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between
fastening torque and fastening time is shown in the
figures.
NOTE:
The size of wood screw which can be fastened
•
with this tool may differ depending upon the type of
material to be fastened. Always perform a test
operation to determine the size of wood screw.
Holding the tool
Hold the tool only by the handle when performing an
operation.
1. Bit
2. Sleeve
5
.
N m
(ft.lbs)
120
(87)
100
(72)
80
(58)
60
(43)
40
(29)
20
(14)
0
Fastening time
009621
.
N m
(ft.lbs)
100
(72)
80
(58)
60
(43)
40
(29)
20
(14)
0
Fastening time
009622
Hold the tool firmly and place the point of the driver bit in
the screw head. Apply forward pressure to the tool to the
extent that the bit will not slip off the screw and turn the
tool on to start operation.
NOTE:
Use the proper bit for the head of the screw/bolt
•
that you wish to use.
Standard bolt
M14(9/16")
M12(1/2")
M14
(9/16")
M10(3/8")
M12
(1/2")
M10
M8(5/16")
(3/8")
M8
(5/16")
3.0
2.0
1.0
(S)
High tensile bolt
M10(3/8")
(3/8")
M8(5/16")
(5/16")
1.0 2.0
(S)
M10
M8
3.0