Troubleshooting; Installation - AEG BE6915001M Notice D'utilisation

3172742-002 In-Fr. (AEG) 17/10/14 09:50 Página 22
22 www.aeg.com
• Exchange the bulb.
• Replace the lens, making sure it fits in
the correct position without forcing it.
10. TROUBLE SHOOTINGS
The oven stops working
• Check the power connection.
• Check the fuses and the circuit
breaker for your installation.
• Make sure the timer is either in the
manual or programmed setting.
• Check the position of the function
and temperature setting.
The light inside the oven does
not go on
• Change the bulb.
• Check that it has been properly
inserted according to the Instruction
Manual.
The heating pilot light does
not turn on
• Select a temperature.
• Select a function.

11. INSTALLATION

This information is exclusively for the
installer, who is responsible for the
oven's assembly and electrical
connection. If you install the oven
yourself, the manufacturer will not
accept liability for possible damage.
11.1 Prior to Installation
Please refer to electrical safety
instructions on page 3 of this manual
before installation.
• It should only come on while the
oven is heating up to the
temperature selected.
Oven smoking during use
• Normal during first use.
• Clean the oven regularly.
• Reduce the amount of grease or oil
in the tray.
• Do not use temperatures higher than
those indicated in the cooking chart.
The expected cooking results
are not achieved
Check the cooking chart for guidance
on how your oven operates.
CAUTION
If these problems persist despite
these tips, contact Technical
Service.
• To unpack the oven, pull on the tab
located at the bottom of the box and
hold it by the side handles, never by
the oven door handle.
• The opening in the kitchen unit must
be that indicated on the diagram. The
minimum size of the unit base must
be 550 mm.