Joyello JL-983 WROOM Mode D'emploi page 19

GB
This car seat can be used in conjunction with its own safety belt harness system for children of the
first weight group. These must be attached by the belt buckle through 3 points within the vehicle.
1. Remove the seat belt from the rear metal buckle lock, positioned on the rear backrest (fig. 2).
2. From the rear seat backrest extract the seat belt covers from their slots (fig.10/11).
3. Disengage the belts from the coupling mechanism in order to extract them from the front part of
the seat. (Fig.12)
4. Lift the coating at the base of the seat and remove the metal hook which is used to fasten part
connected to the coupling mechanism (fig. 13)
5. Remove the coupling mechanism from the seat base (Fig. 14)
6. Unhook the seat belt adjustment metal buckle from the rear lock on the back, positioned on the
rear of the seat (fig. 15)
7. Remove the tape from the base seat adjustment belts (fig. 16)
8. Place the forward-facing child seat in the car, on the positions allowed in the car and adjust the
headrest according to the child's height (Fig. 17)
9. After placing the child, pull the car belts to 3 points (lap and diagonal) by means of the buckle
through the steps (Fig. 18) (under the arm and the abdomen between the backrest and the headrest
diagonally), not twisting them. Put the car seat buckle into the lock mechanism until you hear the
locking "click".
19