Installation Getting Started; Features; Unpacking; Accessories - Wadia INTUITION 01 Mode D'emploi

Installation
Getting Started
The Wadia Intuition 01 is an integrated amplifier with 7 digital inputs with
upsampling to 1.536 MHz. Despite its slim design, the Wadia Intuition 01 is loaded
with technology to bring you the best sound possible.

Features

• 24-bit/1.536MHZ upsampling using Delta-SigMaster algorithm
• Accepts up to a 32-bit/384kHz input data rate with DSD 64/128 playback
• 350 Watt/channel 4 Ohm, 190 Watt/channel 8 Ohm ( EIAJ test 1khz, 1% THD )
• 7 Digital Inputs: 1xUSB, 1xTOSLINK Optical, 2xWadialink, 1xAES/EBU, 2x
Coaxial S/PDIF (RCA)
• 2x Analog input.
• Aluminum Remote Control

Unpacking

Use care in unpacking your Wadia Intuition 01.
Inspect it for any shipping damage and call your dealer immediately if any is found.
Do not plug your Wadia Intuition 01 into an AC outlet if you find shipping damage.
We advise saving all packing materials so that the unit can be easily and safely
shipped if the need arises.
Note: Safely store all the packing materials in a secure place in case
the unit need to be shipped out for service.

Accessories

Provided with the Wadia Intuition 01 are the following accessories:
• AC power cord
• Remote Control
• Wadia USB thumb drive
• 2 red and 2 black male banana plugs for connecting the loudspeakers
• Screwdriver ( to open the remote control when necessary to replace the battery )
• Cleaner + soft cloth

Connecting to AC Power

Check to make sure that the power cord shipped with your Wadia Intuition 01 has
been manufactured for operation at your AC line voltage.
Damage caused by improper operation is not covered by Wadia warranty.
If the included cable and wall termination is different from your AC outlet, contact
your Wadia dealer.
Removing the battery protection on the Remote Control
The Wadia Intuition 01 remote
control requires one CR1216 battery,
which is already installed.
To activate, remove the plastic
protection slip as shown in the
following drawing
EN
9