Front Panel; Selecting The Desired Input - Wadia INTUITION 01 Mode D'emploi

EN
1 2

Front Panel

1 Select the previous input
2 Select the next input
3 Display
4 Volume down
5 Volume up
Note: The 1,2,4,5 buttons are placed under the fabric that covers the
display and are located by 4 small white lighting spots.
12
INPUTS
SPEAKER OUTPUTS
1
BANANA
1 ANALOG 2
3 4 5
Power
The power switch is located on the back panel of the Wadia Intuition 01 right
above the AC inlet.
When the apparatus is switched on, a sequence of tests indicating the name
Wadia and after this the product name and the currently selected input appear on
the screen. After this sequence, four lit points that form a square are shown in the
centre of the display, indicating that the apparatus is ready for use.
Selecting the required input
Press keys 1 or 2 to scroll left and right among the various inputs and select the
one that is required.
If, for example, the USB input is currently active, pressing key 1 activates the
Toslink optical input.
The same logic is also valid for the remote control, using the keys on its vertical
axis.
Note : The input selector has a memory, therefore the apparatus re-
members the name of the last input used by the user before switching
off, and re-proposes it when the device is switched on the next time.
Adjusting the volume
The volume level is controlled by keys 4 and 5 on the front panel, or by the remote
control using the 2 keys on its horizontal axis.
The keys must be kept pressed to increase or decrease the volume until the
required level is obtained; the volume scale is divided into 100 steps that are well
represented on the apparatus display and which can be read even from a distance.