Unit Description; Operation - Beurer ELLE HDE 10 Mode D'emploi

5. unit description

1
7

6. operation

Important
• Set the correct operating voltage (100-120 V
or 220-240 V) before using the device for the
fi rst time.
• If you do not know the local mains voltage,
request it from the relevant organisation.
• Do not jam the mains cable [6] in drawers or
doors, for example.
• Untangle the mains cable [6] if it is twisted.
• Do not pull, twist or bend the mains cable
[6] and do not pull or route it over/on sharp,
pointed objects or hot surfaces.
Warning
• Position yourself on a dry, non-conductive
surface.
1 Removable, rotating professional nozzle
2
2 Protective grille with lint fi lter
3 Folding device handle
4 Sliding switch with three settings:
0 Off
1 Low air fl ow, warm air
2 High air fl ow, hot air
3
5 Anti-kink protection with hanging eyelet
6 Mains cable
4
7 Voltage switchover
5
6
• Make sure that your hands are dry!
• Dry your hair with a towel beforehand.
• The professional nozzle [1] and device may
become very hot depending on the switch
setting and period of use – risk of burns and
fi re!
• Do not touch the professional nozzle [1].
• Allow the professional nozzle [1] to cool down
before removing it.
• Place the device on fi reproof surfaces only.
• Ensure that no highly fl ammable liquids are
located near the device.
• Do not use the device on synthetic hair – risk
of fi re!
• Ensure that no hair can be directly sucked into
the device.
12