Installation - AEG HK683326XG Notice D'utilisation

16 www.aeg.com
If you tried the above solutions and can-
not repair the problem, speak to your
dealer or the customer service. Give the
data from the rating plate, three digit
letter code for the glass ceramic (it is in
the corner of the glass surface) and an
error message that comes on.

8. INSTALLATION

WARNING!
Refer to the Safety chapters.
Before the installation
Before the installation of the appliance,
record the information below from the
rating plate. The rating plate is on the
bottom of the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................
8.1 Built-in appliances
• Only use the built-in appliances after
you assemble the appliance into cor-
rect built-in units and work surfaces
that align to the standards.
8.2 Connection cable
• The appliance is supplied with the
connection cable.
• Replace the damaged mains cable on-
ly with the spare parts cable. Speak to
your local Service Centre.
One phase connection — 230 V~
230V~
N
L
Green — yellow
N Blue and gray
L Black and brown
Make sure, you operated the appliance
correctly. If not the servicing by a cus-
tomer service technician or dealer will
not be free of charge, also during the
warranty period. The instructions about
the customer service and conditions of
guarantee are in the guarantee booklet.
Two phase connection
1. Remove the cable end sleeve from
black and brown wires.
2. Remove insulation of the brown and
black cable ends.
3. Apply a new wire end sleeve of 1.5
mm² on each cable end. (Special
tool required)
WARNING!
All electrical connections must
be made by a qualified electri-
cian.
CAUTION!
Do not drill or solder the wire
ends. This is strictly forbidden!
WARNING!
Do not connect the cable with-
out cable end sleeve.
400V 2~N
Two phase connection — 400 V 2 ~
Green — yellow
Blue and gray
Black
N
L1
L2
N
N
L1