Clean Lock; Switching Ice Cube Production On Or Off; Eco Mode; Self-Test - Thermador T18ID905RP Guide D'utilisation

Clean lock

You can use this function to switch off the touch
function of the controls for 10 seconds. During this
time you can clean the display.
~ "Cleaning the display" on page 24
Press " button to open the Settings menu.
1.
Press < button.
2.
The cleaning display appears, and the countdown
starts.
Automatic clean lock
You can use this function to select whether the
automatic clean lock is switched on automatically
when the door is opened.
Press " button to open the Settings menu.
1.
Use ( button to move to the menu item Appliance
2.
settings.
Press 8 button.
3.
Press ) button to move to the menu
4.
item Automatic clean lock.
To change the setting, press : button.
5.

Switching ice cube production on or off

9
CAUTION
Damage to the appliance!
Never store bottles or food in the ice cube
container, even for short periods. This can
block and damage the ice maker.
Ice cube production starts as soon as the appliance
has reached the set temperature.
Note: Ice cube production stops automatically when
the ice cube container is full.
Switching ice maker on or off
Press " button to open the Settings menu.
1.
Use ) button to move to the menu item Ice cube
2.
production.
Press </= button.
3.
Reset water filter counter
After replacing the water filter, you have to reset the
water filter counter.
Press " button to open the Settings menu.
1.
Operating the appliance en-us
Use ) button to move to the menu item Reset
2.
water filter counter.
Use 8 button to confirm, and confirm the query
3.
again with 8 button.
Note: If you cancel the query or take longer than
10 seconds to make an input, the water filter counter
will not be reset.
Switching the water filter counter on and off
If you have replaced the water filter with a particle
filter, switch the water filter counter off. It is not
needed in this case as the particle filter does not
have to be replaced.
Press " button to open the Settings menu.
1.
Use ( button to move to the Appliance settings
2.
menu.
Press 8 button.
3.
Press ) button to move to the menu item Water
4.
filter counter.
To change the setting, press : button.
5.

Eco mode

Eco mode switches the appliance to energy-saving
operation.
The appliance automatically sets the following
temperatures:
Freezer compartment: +3 °F (-16 °C)
■
Switching Eco mode on or off
Press " button to open the Settings menu.
1.
Press ) button to move to the menu item Eco
2.
mode.
Press </= button.
3.
The temperature is changed and the display shows
the new temperature. When Eco mode is switched
off, the recommended temperature is set.
Note: You can also switch Eco mode on or off by
adjusting the temperature with +/- buttons.

Self-test

This function can be used to start fault analysis on
your appliance.
~ "Appliance self-test" on page 28

Setting the brightness of the control panel

Press " button to open the Settings menu.
1.
Use ( button to move to the menu item Appliance
2.
settings.
Press 8 button.
3.
Press : button to open the menu
4.
item Brightness.
Press ( ) buttons to set the required brightness.
5.
Press 8 button.
6.
The setting is saved.
Press ; button to exit the menu.
7.
15