Italiana Camini CLASSICA Installation, Usage Et Maintenance page 26

Commissioning must be done by a Technical Service Centre
authorised by Edilkamin (CAT) prior to ignition and testing
according to the UNI 10683.
This standard indicates the control operations to be carried out
in situ, aimed at ascertaining correct system function.
The CAT will also provide for calibrating the stove on the
basis of the type of pellets and the installation conditions, thus
allowing for the effectiveness of the guarantee.
Failure to have the stove ignited by an authorised C.A.T. pre-
vents Edilkamin from guaranteeing correct functioning.
for information see the www.edilkamin.com website
There may be a slight smell of paint the fi rst few times it is
ignited, however, this will disappear quickly.
Before igniting you must check:
• that installation is correct
• the power supply
• that the door closes properly to a perfect seal
• that the combustion chamber is clean
• that the display is on standby (the date, power or temperature
fl ashes).
LOADING THE PELLETS INTO THE HOPPER
Remove the metallic cover in order to fi ll the hopper
ATTENTION:
use the glove supplied when fi lling the stove whilst it is run-
ning and therefore is hot.
fi g. 1
INSTRUCTIONS FOR USE
*
(fi g. 1).
*
- 26
NOTE regarding the fuel.
The stoves is designed and programmed to burn wood pellets
with 6 mm diameter.
Pellets are a type of fuel in the form of little cylinders, made
from compacted sawdust, compressed under high pressure
with no adhesives or foreign materials.
They are sold in bags of 15 kg.
For the stove to function properly, you MUST NOT burn
anything else in it. Using other materials (including wood)
will render the warranty null and void. Such use is detected by
laboratory analyses. Edilkamin has designed, tested and pro-
grammed their stoves to guarantee the best performance when
pellets with the following characteristics are used:
diameter: 6 millimetres
maximum length: 40 mm
maximum moisture content: 8%
calorifi c value: at least 4300 kcal/kg.
If pellets with different characteristics are used, the stoves
must be recalibrated a similar procedure to that carried out by
the DEALER when the stove is ignited the fi rst time.
Using unsuitable pellets may: decrease effi ciency; cause
malfunctions; stop the stove from functioning due to clogging,
dirt on the glass, unburnt fuel, etc.
A simple, visual analysis of the pellets may be carried out:
Good quality: smooth, uniform length, not very dusty.
Poor quality: with longitudinal and transverse cracks, very
dusty, various lengths and mixed with foreign matter.
-