Edesa 4 SE Notice D'utilisation page 52

CLEANING THE HUMIDITY CONTROL PROBE
GB
After numerous drying cycles a thin film of scale
may deposit on the humidity control probe inside
the drum.
This film may compromise drying performance.
Clean the scale off the stainless steel probe with a
cloth and a solution of vinegar and water.
N.B. Failure to implement these safety and maintenance recommendations may
cause serious accidents and irreparable damage to the dryer (corrosion and fire).
If your dryer isn't working properly, make sure that:
•
it's plugged in properly;
•
you've pressed the "start" button;
•
you've closed the door properly;
•
you've put the filter in its housing properly;
•
your home's automatic circuit breaker hasn't operated;
•
it isn't too cool in the room where the appliance is installed (ie. under 10° C);
•
the air outlets and flexible hose (if installed) are not blocked.
If your drying results aren't satisfactory, check that:
•
you've haven't put too much laundry in the dryer;
•
you've selected the laundry appropriately and chosen the right programme for the
type of laundry you want to dry;
•
you've cleaned and fitted the filter properly;
•
it isn't too cool in the room where the appliance is installed (ie. under 10° C);
•
the air outlets and flexible hose are not blocked.
W W H H A A T T T T O O D D O O I I F F ... ...
- 52 -