Edesa 4 SE Notice D'utilisation page 51

In this phase an intermittent acoustic signal will remind you that the laundry can now
GB
be taken out at any time.
At the end of the anti-crease phase, end of cycle led (9) comes on to indicate that
the cycle is over.
If any items aren't sufficiently dry, put them back in the dryer and finish off with one
of the time programmes (from 15 to 60 minutes).
NB.: Remember to switch the dryer off, using the ON-OFF button, at the end of
each drying cycle.
To modify the programmed cycle or delay time once the dryer has started turn
the programme switch to "0" reset position, wait for the acoustic signal and
repeat the procedure described above.
WARNING
If there is a power failure during the drying cycle or the delay period, when the
power returns, the dryer restarts the cycle where it stopped.
If the door is opened during the drying cycle, press the "start" button again to
restart the machine.
IMPORTANT
Never use the set-time programmes for delicate or completely synthetic fabrics.
Remember to clean the filter after each drying cycle.
C C L L E E A A N N I I N N G G A A N N D D M M A A I I N N T T E E N N A A N N C C E E
CLEANING THE BODY
Never use aggressive or abrasive products to
clean the body or control panel. A damp cloth is
sufficient, with some soap if necessary.
The filter system in this dryer is a removable
element sunk into the lower part of the hatch and
is removed by lifting up and out.
The fibres that collect inside the filter are normal
wear from the fabrics and are not the result of
any malfunctioning of the dryer. The filter can be
cleaned with a toothbrush or a damp cloth.
N.B. DO NOT CLEAN WITH WATER
- 51 -