Campingaz Master 3 Série Woody Mode D'emploi page 26

V. TROuBLESHOOTING
Problem
The lighting of the
control panel does not
work.
There is a continuous
ignitor discharge.
There is ignitor
discharge - all of the
knobs are in closed
position or between
the Max and Mini
positions.
There is no ignitor
discharge.
difficulty in lighting up
GB
difficulty in lighting up
The flames are not
stable when a new
cylinder is used.
The burner will not
light.
The burner does not
burn smoothly or goes
out.
Large plume of flame
on the burner surface
Flame at the injector
The thermometer
does not show
a consistent
temperature.
Insufficient cooking
temperature
The grease ignites in
an abnormal manner.
Troubleshooting
y Check that the batteries are properly installed
or are not empty.
y Check that the ON/OFF button of the battery
compartment has been activated.
y Check that the terminals of the battery
compartment are properly connected.
y Check that the wires of the electrical circuit
are in good condition and properly connected.
y Check that the knobs are not in an open
position between the closed and MAX
positions.
y Check the cables and position of the tap cam.
y Check that the battery has been properly
installed (the + towards the cap).
y Check that the wires of the electrical circuit are
in good condition and connected.
y Check that you keep the knob in the Ignition
position for sufficient time.
y Check that the ground wire is connected.
y Check that the regulator matches the type of
gas and recommended pressure.
y Check that the regulator is not in safe mode.
y Check that the regulator and hose are in good
condition.
y Check that the cylinder is not empty or almost
empty.
y Possible presence of air in the cylinder and
thus in the gas circuit.
y Check that the hose, injector, tap, venturi tube
and burner holes are not clogged.
y Check that the burner outlet properly covers
the injector.
y Check that there is sufficient gas in the
cylinder.
y The burner outlet may be blocked (spider
webs,...) or the injector holder is improperly
positioned in the outlet.
y Check that the cylinder is not almost empty.
y Check that the injector or Venturi tube is not
blocked (spider webs...).
y Check that grease has not accumulated on
the grease tray and/or burner protection.
Corrective Actions
y Change the direction of the batteries or put in new
batteries.
y Set the button to the "ON" position.
y Connect the two terminals.
y Change the wires or connect the disconnected or
initially misplaced wires.
y Place all the knobs in the "O" position or between
the MAX and MINI positions.
y Contact the After Sales Service.
y Change the direction of the batteries.
y Reverse the wires and reconnect if necessary.
y Keep the knob in the ignition position for a longer
time.
y Contact the After Sales Service.
y Change the regulator if it does not match.
y Reset the regulator.
y Replace the hose and/or regulator if they are in
poor condition.
y Change the cylinder if necessary.
y Let the barbecue work and the problem will
disappear.
y Blow in the burner.
y Clean the Venturi tube.
y Reposition the burner outlet.
y Change the gas cylinder.
y Clean the Venturi tube and/or reposition the burner.
y Change the cylinder.
y Contact the After Sales Service.
y Change the thermometer.
y Clean the Venturi tube.
y Reduce the gas flow of the barbecue.
y Clean the grease tray and/or burner protection.