DHG 46502007 Manuel D'utilisation page 5

StretcherSling can only be applied and removed when the patient is lying down
Removal of the StretcherSling
I F U
1
2
3
4 5
1
2
1. Turn the patient towards you. Place StretcherSling
so that the product label is facing the underlying surface
and the sling's mid-section follows the patient's spine.
The upper edge of StretcherSling should support
the head.
Place the edge of the sling as far in under the patient
as possible. Guide the loops under, so that you can
reach them once you have turned the patient back
onto StretcherSling.
2. Turn the patient back onto the sling and pull the sling
out from the other side with the help of the straps.
3. If necessary: Adjust the width of the StretcherBar
to fit the patient's width by pulling out the lift hooks.
Then, hook the lift loops onto the bar.
4. Raise the lift until all loops are fully extended. Pause
to ensure that everything is as it should be before raising
the patient clear of the underlying surface.
5. If the patient is not balanced after being lifted from
the underlying surface, this can be corrected turning the
balance regulator.
1. Release all suspension hooks from the lift and move
it out of the way. Turn the patient toward you and tuck
StretcherSling in under itself against the underlying
surface.
2. The fabric slides against itself when you pull out
StretcherSling, after turning back the patient.
5