Instrument Panel; Use - DeVilbiss Healthcare Drive ENVOY Mode D'emploi

Instrument panel

1. Battery display
2. Speed controller
3. Warning light
4. Horn
5. Indicators
6. Light switch - headlight
7. Control lever
8. Fast (H) / slow (L) drive switch
7 6

Use

Ignition key
To start the electric scooter, turn the key to the right; the
instrument panel is now lit up. To switch off, turn the key
to the left; the instrument panel turns off and the key can
be removed.
Warning: Never switch off the ignition while you are
driving since this leads to an immediate stop and possi-
ble damage or injury.
Control levers
The electric scooter is driven by operating the control
lever on the side of the instrument panel. To drive the
electric scooter forwards, move the right control lever in
the direction of the operator. To drive the electric scooter
backwards, move the left control lever in the direction of
the operator. The horn generates a beep when the ve-
hicle moves backwards. The longer the control lever is
pressed, the faster the electric scooter moves.
To stop the electric scooter, release the control lever; the
electromagnetic brake automatically engages.
Warning: Never operate the left and right control levers
at the same time.
Brakes
By releasing the control lever, the vehicle brakes auto-
matically. When the vehicle comes to a stop, the mag-
netic brake automatically closes. The scooter is now se-
cured against rolling away.
In an emergency, the user can stop the electric scooter
by operating the hand brake on the left on the hand grip
of the steering column.
Drive Medical GmbH & Co. KG | As per: 10.08.2020 | Errors and alterations excepted
Warning: Never put the vehicle into neutral on inclines. In
this case, the brake will not grip.
Setting the speed
The speed of the electric scooter can be increased by
turning the speed controller to the right (rabbit symbol) or
reduced by turning the speed controller to the left (turtle
symbol).
Warning: Never adjust the speed setting while driving
since this can lead to a loss of control. Do not select the
maximum speed when driving indoors.
When the electric scooter is used indoors or in pedes-
trian areas (such as sidewalks or shopping areas), the
lowest speed setting should be selected. If the electric
scooter is used on the street, the high speed setting can
be selected.
Press the "H/L" button (pic. 1) to switch between the two
speed levels. In the slow speed level, the speed is re-
duced by about half.
Warning: Always use the low speed setting when you
are driving indoors or on a sidewalk.
Note: Set the speed to maximum to drive up an incline
and to minimum for driving downhill.
Horn
By pressing the "horn" button, a beep sounds; the beep
is muted as soon as you release the button.
Indicators
Use the respective indicator to indicate your direction
when driving around a curve. Press the same button
again to switch off the indicator.
Light
Press the light button once to switch on the headlights.
Press the light button again to switch off the headlights.
EN
21
Instructions for use ENVOY