Connecting Wires To Terminals - JVC KW-V51BT Mode D'emploi

CONNECTION/INSTALLATION CONNECTION/INSTALLATION
Connection

Connecting wires to terminals

Pages 56 – 57
USB terminal (0.8 m):
Pages 56 – 57
Connect the antenna
cord to the antenna
terminal.
1
White ª / White with black stripe · : To front speaker (left)
Gray ª / Gray with black stripe · : To front speaker (right)
Green ª / Green with black stripe · : To rear speaker (left)
Purple ª / Purple with black stripe · : To rear speaker (right)
Blue (Power antenna wire)
Blue with white stripe (Remote output wire)
Light blue with yellow stripe (Steering remote control wire)
Orange with white stripe (Dimmer control wire)
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
REVERSE
Page 58
Pages 56 – 57
PRK SW
10 A fuse
Connect SiriusXM Connect Vehicle Tuner
(commercially available).*
*
2
(POWER ANTENNA)
(REMOTE OUTPUT)
(STEERING WHEEL REMOTE)
(ILLUMI)
(ACC)
(BATT)
(GND)
Connect to the vehicle's reverse lamp harness when
Purple with white stripe
using the optional rear view camera.
(Reverse sensor wire)
Light green
(Parking sensor wire)
3
1 (Page 57)
* Only for KW-V51BT Region 1/KW-V31BT Region 1.
1
* 2 If no connections are made, do not let the cable come out from
the tab.
To automatic antenna if any (250 mA max.)
To the remote lead of other equipment (200 mA max.)
To the OE remote adapter matching your car
To car light control switch
To car chassis
Connect to the vehicle's parking
brake detection switch harness.
• For best safety, be sure to
connect the parking sensor.
Ignition key switch
Fuse box
Battery
ENGLISH 55