Resetting The Spotlight; To Its Factory Settings; Cleaning The Spotlight; Specifications - IMG STAGELINE ODC-100/ RGB Mode D'emploi

5.4 Resetting the spotlight

to its factory settings

The factory settings of the spotlight are as fol-
lows:
Function
number of DMX channels
max. brightness
white balance function
subaddress function
slow LED response
subaddress
11 shades of white
white balance
DMX / independent
mode or slave mode
To reset the spotlight to its factory settings:
1) Press the button MENU repeatedly until the
highest menu level has been reached.
2) Press the button UP or DOWN repeatedly
until the display indicates
3) Press the button ENTER. The display
changes to ,
or .
4) Press the button UP or DOWN repeatedly
until the display indicates
5) Press the button ENTER so that the display
indicates four entry positions (. . . .). Then
press the following buttons:
UP, DOWN, UP, DOWN.
Each time one of these buttons is pressed,
an asterisk ( ) will appear on the display.
6) To reset the settings, press the button
ENTER (the display briefly indicates
to cancel the procedure, press the button
MENU.
7) To be able to control the spotlight by DMX,
use the button MENU to return to the highest
menu level.
For independent operation, use the but-
ton MENU to select the operating mode and
then press ENTER to activate the mode
selected.
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
Factory setting
= 10 channels
= 100 %
= slowest
01
factory settings
R = 255, G = 255,
B = 255
= DMX / inde-
pendent operation
.
, , ,
.
) or,
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
®

6 Cleaning the Spotlight

Clean the pane in front of the LED at regular
intervals depending on impurities. This is the
only way to ensure that light will be emitted at
maximum brightness. Before cleaning, dis-
connect the mains plug from the socket.
Only use a soft clean cloth and a glass cleaner.
For cleaning the other parts of the housing
of the PARC-100 / RGB, only use a soft clean
cloth. Never use any fluid; it may leak into the
spotlight and damage it.
The weatherproof housing of the ODC-
100 / RGB may also be cleaned with a damp
cloth and a mild detergent.

7 Specifications

Data protocol: . . . . . . . . . . . DMX 512
Number of DMX channels: . selectable:
Light source: . . . . . . . . . . . RGB COB LED
Power consumption: . . . . 100 W
Beam angle: . . . . . . . . . . 60°
DMX connections: . . . . . . . XLR, 3 poles
Pin assignment: . . . . . . . Pin 1 = ground
Power supply: . . . . . . . . . . 230 V~ / 50 Hz
Power consumption: . . . . . 120 VA max.
Protection of housing: . . . . IP 66 (ODC- only)
Dimensions w/o
mounting bracket: . . . . . . . ∅ 185 × 250 mm
Weight: . . . . . . . . . . . . . . . . 6.5 kg
Subject to technical modification.
3, 4, 5 or 10
Pin 2 = DMX-
Pin 3 = DMX+
23