Publicité
1.6.7. Do not use the charger with damaged cord or plug. Damage should be repaired by a
qualified person.
1.6.8. Do not use the charger after it has been hit, dropped or otherwise damaged. Entrust the
testing and potential repair to authorized RAIDER service workshop.
1.6.9. Do not try to dismantle the charger. All repairs are to be made by an authorized RAIDER
service workshop. Improper charger assembly may cause electric shock or fire.
1.6.10. Disconnect the charger from a power supply before starting any maintenance or cleaning.
1.6.11. Disconnect the charger from mains network when it is not in use.
2. Construction and use.
Drill is a battery-powered tool. cordless drill consists of brushless electric motor and planetary gear.
Drill is designed for screwing in and out screws and bolts in wood, metal and plastics and for drilling
holes in these materials. Cordless, battery-powered power tools are especially useful for works in
interior furnishing, adaptation of premises etc.
Use the power tool according to the manufacturer's instructions only.
3. Noise level and vibration parameters.
Sound pressure: Lp
Sound power: Lw
A
Vibration acceleration: a
4. Preparation for operation.
4.1. Inserting and removing the battery.
Set the direction selector switch (2) in middle position.
Push buttons (6) and slide the battery (7).
Insert charged battery (5) into the handle holder. You should hear when the lock buttons (6) snap.
4.2. Charging the battery.
Cordless drill is supplied with partially charged battery. Charge the battery full before use. Charging
the battery should be carried out in temperature between 4°C to 40°C. New battery, or one that have
not been used for a long time, will reach full efficiency after approximately 5 charge/discharge cycles.
The mains voltage must match the voltage on the charger rating plate.
Always check technical condition of the charger, charging station and power cord before starting
to charge.
When charging the battery, use only the charger and the charging station supplied with the drill.
Do not expose the charger and charging station to rain or splashing.
4.2.1. Set the direction selector switch (2) in middle position.
4.2.2. Remove the battery (7) from the drill.
4.2.3. Insert the battery (7) into the socket of the charging station
4.2.4. Connect charger power cord to the socket of the charging station.
4.2.5. Connect the charger to mains socket (220V).
Depending on battery discharge level, the battery will be charged after 3-5 hours.
4.2.6. Disconnect power supply before removing the battery from the charger. Avoid consecutive
short chargings. Do not charge the battery after short use of the drill. The battery and the charger heat
up during charging. This is normal. Significant decrease of the period between chargings indicates the
battery is used up and should be replaced.
5. Operation and settings. Switching on. Switching off.
5.1. Switching on - press the switch button (1).
5.2. Switching off - release the switch button (1).
5.3. Rotational speed control.
Screwing or drilling speed can be controlled during operation by increasing or decreasing pressure
on the switch button (1). Speed control enables soft start, which prevents drill slip when drilling in
gypsum or glaze and helps to control the operation when screwing and unscrewing.
= 86.9 dB(A) K=3 dB(A)
A
= 97.9 dB(A) K=3 dB(A)
= 1.480 m/s
< 2,5 m/s
2
hD
, K=1.5 m/s
.
2
2
13
Publicité
