Operation; Changing The Setpoint Temperature; Changing Between Fahrenheit And Celsius - Hatco Flav-R-SavOR FS2HaC Série Manuel D'installation

OPERaTION

General
WARNING
Read all safety messages in the IMPORTaNT SaFETy
INFORMaTION section before operating this equipment.
Startup
NOTE: Keeping the sheet pans behind the arrows allows the
air currents in the unit to flow properly and maintain the
required temperature.
Arrow
Warning Light
Power I/O (On/Off)
Switch
BURN HazaRD:
• Some exterior surfaces on unit will get hot. Use caution
when touching these areas.
• Pan/tray will be very hot upon removal—use oven mitt,
protective clothing, or pan gripper to remove.
Full-Size
Sheet Pan
CAUTION
NOTE: The digital temperature controller is factory pre-set to a
setpoint temperature of 87°C (190°F). Once the setpoint
temperature is changed, the new setpoint temperature
will remain in memory until it is changed again.
NOTE: If the warning light illuminates during operation, a
blower malfunction has occurred. Turn off unit and
contact an Authorized Service Agent or Hatco for
assistance.
Shutdown
NOTE: A cooling fan inside the unit will run for a short time after
the unit is turned off.

Changing the Setpoint Temperature

Changing Between Fahrenheit and Celsius