Important Safety Information - Hatco Flav-R-SavOR FS2HaC Série Manuel D'installation

Read the following important safety information before using this equipment to avoid
serious injury or death and to avoid damage to equipment or property
WARNING
ElECTRIC SHOCk HazaRD:
• Plug unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. If
plug and receptacle do not match, contact a qualified
electrician to determine and install proper voltage and
size electrical receptacle.
• Units supplied without an electrical plug require field
installation of proper plug. Plug must be properly
grounded and of
configuration for electrical specifications of unit.
Contact a qualified electrician to determine and install
proper electrical plug.
• Turn OFF power switch, unplug power cord, and allow
unit to cool before performing any cleaning,
adjustments, or maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Unit is not weatherproof. locate unit indoors where
ambient air temperature is a minimum of 21°C (70°F).
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
• Do not steam clean or use excessive water on unit.
• Do not pull unit by power cord.
• Discontinue use if power cord is frayed or worn.
• Do not attempt to repair or replace a damaged power
cord. Cord must be replaced by an authorized Hatco
Service agent or a person with similar qualifications.
• Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment.
FIRE HazaRD: locate unit a minimum of 25 mm (1") from
combustible walls and materials. If safe distances are not
maintained, discoloration or combustion could occur.
This unit is not intended for use by children or persons
with reduced physical, sensory, or mental capabilities.
Ensure proper supervision of children and keep them away
from the unit.
Make sure all operators have been instructed on the safe
and proper use of the unit.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an authorized Hatco Service
agent or contact the Hatco Service Department at
414-671-6350; fax 414-671-3976.
correct voltage, size,

IMPORTaNT SaFETy INFORMaTION

BURN HazaRD:
• Some exterior surfaces on unit will get hot. Use caution
when touching these areas.
• allow unit to cool before performing any cleaning,
adjustments, or maintenance.
• Pan/tray will be very hot upon removal—use oven mitt,
protective clothing, or pan gripper to remove.
and
locate unit at proper counter height in an area that is
convenient for use. location should be level to prevent unit
or its contents from falling accidentally and strong enough
to support weight of unit and contents.
The National Sanitation Foundation (NSF) requires that
units over 914 mm (36") in width or weighing more than
36 kg (80 lbs.) either be sealed to or raised above the
installation surface. If unit cannot be sealed at the point of
use, 102 mm (4") legs are included to allow for proper
cleaning access below unit.
Do not lay unit on the side with the control panel or damage
to unit could occur.
Use non-abrasive cleaners and cloths only. abrasive
cleaners and cloths could scratch finish of unit, marring its
appearance and
accumulation.
Clean unit daily to avoid malfunctions and maintain
sanitary operation.
.
CAUTION
NOTICE
making it susceptible to soil