Maintenance; Daily Cleaning - Hatco Flav-R-SavOR FS2HaC Série Manuel D'installation

Masquer les pouces Voir aussi pour Flav-R-SavOR FS2HaC Série:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 40

MaINTENaNCE

General
WARNING
ElECTRIC SHOCk HazaRD:
• Turn OFF power switch, unplug power cord, and allow
unit to cool before performing any setup, cleaning, or
maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on unit.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
• Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an authorized Hatco Service
agent or contact the Hatco Service Department at
414-671-6350; fax 414-671-3976.

Daily Cleaning

NOTICE
Use non-abrasive cleaners and cloths only. abrasive
cleaners and cloths could scratch finish of unit, marring its
appearance
and
making
accumulation.
NOTE: A cooling fan inside the unit will run for a short time after
the unit is turned off.
it
susceptible
to
soil

Publicité

Table des Matières
loading

Table des Matières