Vermeiren Sedna Manuel D'utilisation page 22

EN
NL
CAUTION
In case of any problems, read the instructions of the battery charger or contact your
specialist dealer.
Follow next instructions for charging:
1. Switch the scooter OFF.
2. FIRST connect the charger to a 230V AC power
socket. The indicator goes on (green) to show that
the charger is powered. If not, check the charger's
manual before connecting it to the battery. If the
indicator lights alternating in green and red, there is
some fault. Do not use the charger.
3. Slide/turn the cover (39) of the charging point on the
battery open.
4. Connect the battery to the charger. During charging
lights the indicator red.
5. Wait till the battery is fully loaded. The indicator light
turns green again.
6. Disconnect the battery and slide the cover plate
back in place.
7. Switch the scooter on and check if all lights of the
battery status indicator are on.
8. Remove the charger from the socket, let it cool down
and store it on a dry location.
Depending on battery condition, it will be charged after 4 up to 10 hours. Charging for a longer
period won't harm the battery; but do not charge for more than 24 hours. By daily use of your
scooter we recommend to charge the batteries for 8 to 10 hours after use.
When the battery does not charge properly, the charging will stop after 5 hours and the status
indicator will blink every second. Further loading is of no use.
The charging process can be stopped or started any time by following the instructions above.
Risk of damage
Protect your battery from large sources of electromagnetic radiation.
EN - 18
Using your scooter
Connection point for battery charger
Sedna
2019-02