Wireless Charging; System Settings - ready2music aurora+ Mode D'emploi

WIRELESS CHARGING

This unit will wirelessly charge Qi compatible wireless charging
phones. PMA wireless charging system is not supported.
CAUTION: Remove metal protective or magnetic case
from phone before charging. When charging phone, do
not place magnetic-striped or other metal objects on the
charger. Doing so could damage the object or this unit.
Center Qi compatible device with back side down on the
ready2music logo.

System Settings

How to enter this submenu
1. Press MENU button during DAB or FM mode
2. Press " " or " " button to select System setting submenu
3. Press / OK button to enter the System setting submenu.
4. Press " " or " " button to select & press /OK button the sub-
directory.
Factory Reset
A factory reset clears all user defined settings, replacing them
with the original default values, so time/date, DAB/FM station list
and preset stations are all lost.
If you select Reset, you are asked to confirm by selecting "Y".
SW Version
Press MENU button, then press"
press /OK button to display the current software version.
40
" or " " button to select and
TROULBSHOOTING
Problem Cause
No sound Volume is too low
Poor sound quality Radio signal too
in Radio mode weak
No audio signal No audio signal
via the Bluetooth via the Bluetooth
connection connection
Volume level is set
too low
FM: Hiss Low signal strength
DAB: intermittent
cut-out DAB: „No
stations available"
message
Bluetooth can not Pairing does not
be connected work
Audio source
is switched off
Bluetooth is
switched off at the
audio source.
Bluetooth version is
not supported.
Poor sound Bluetooth device
quality from a is almost out of
Bluetooth® device range of the
unit
EN
Solutions
Increase the volume
Try to adjust the
antenna
position.
Check whether a
connection exists. If
necessary, pair the
speaker again to the
audio source.
Increase the volume
on the speaker
Increase the volume
on the audio source.
Check/move
antenna
Move radio
Rescan local
Check whether
the audio source
supports A2DP
Switch on the audio
source
Switch on the
Bluetooth
function in the
audio source.
Use a different
playback unit.
Move your
Bluetooth device
closer to the unit
41