Safety Instructions - ready2music aurora+ Mode D'emploi

Safety instructions

When used in the correct manner, this unit has been designed
and manufactured to ensure your personal safety.
However, improper use can result in potential electrical shock
or fire hazards. Please read all safety and operating instructions
carefully before installation and use, and keep these instructions
handy for future reference. Take special note of all warnings
listed in these instructions and on the unit.
Water and Moisture
The unit should not be used near water. For example: near
a bathtub, washbowl, kitchen sink, laundry tub, swimming
pool or in a damp basement. Care should be taken so that
objects do not fall and liquids are not spilled into any
openings or vents located on the product.
Cleaning
Do not use water, alcohol or chemicals to clean the
device. When cleaning, disconnect the device from any
power source.
Ventilation
The unit should be situated so that its location or position
does not interfere with its proper ventilation.
For example, it should not be situated on a bed, sofa,
rug or similar surface that may block the ventilation
openings. Also, it should not be placed in a built-in instal-
lation, such as a bookcase or cabinet, which may impede
the flow of air through the ventilation openings.
Heat
The unit should be situated away from heat sources such
as radiators, heat registers, stoves or other appliances
(including amplifiers) that produce heat.
Power Source
The unit should be connected to a power supply only of
the type described in the operating instructions or as
marked on the appliance.
26
Lightning and Power Surge Protection
Unplug the unit from the wall outlet. This will prevent
damage to the product due to lightning and power-line
surges.
Overloading
Do not overload wall outlets, extension cords, or integral
convenience receptacles as this can result in a risk of fire
or electric shock.
Periods of Non-use
If the unit is to be left unused for an intended period
of time, such as a week or longer, the power adaptor
should be unplugged from the unit to prevent damage or
corrosion.
Servicing
The user should not attempt to service the unit beyond
those methods described in the user's operating instruc-
tions.
Service methods not covered in the operating instruc-
tions should be referred to qualified service personnel.
Damage Requiring Service
This unit should be serviced by qualified service personnel when:
• Objects have fallen or liquid has been spilled into the
enclosure.
• The unit has been exposed to rain.
• The unit has been dropped or the enclosure damaged.
• The unit exhibits a marked change in performance or does
not operate normally.
If you have problems with your device, please contact the support
hotline on page 42.
EN
27