Kyocera DF-760 Manuel D'utilisation page 21

Emptying the Punch Waste Box
If a message is displayed on the machine operation panel indicating that the waste punch box is full, be sure to
empty the scraps in the punch waste box.
Leave the main power switch on the machine switched ON ( | ) while performing this procedure.
DF-760, MT-720, BF-720, PH-5A, PH-5B AND PH-5C OPERATION GUIDE
1
Open the front cover.
2
Grasp the punch waste box handle and remove
the box from the Document Finisher.
NOTE:
Take care not to spill the waste hole punch
scraps when removing the container.
3
Dispose of the hole punch scraps appropriately.
4
Re-install the punch waste box. Align it with the
guides in the Document Finisher.
5
Close the front cover.
English
19