Kyocera DF-760 Manuel D'utilisation page 16

English
Interrupt Mode
14
NOTE:
for more detailed information.
2
NOTE:
for Document Processor and Platen specifications.
3
4
NOTE:
therefore the location of the holes may vary on each
sheet.
On completion of the job, remove all the copies.
1
NOTE:
operation, see the machine Operation Guide. Specify
the output tray at the machine.
2
3
4
DF-760, MT-720, BF-720, PH-5A, PH-5B AND PH-5C OPERATION GUIDE
Refer to the Operation Guide for the machine
Load the originals in the Document Processor, or
one at a time on the Platen.
Ensure the orientation of the originals is the same
as that selected for Hole Punch mode on the
machine.
Refer to the Operation Guide for the machine
Select other features as required and press Start.
The copies are automatically hole punched and
ejected onto the selected tray.
Holes are punched in each copy individually,
Specify the settings for interrupt mode at from the
machine operation panel.
For more information on interrupt mode
Take out the any existing original and set the
original to use for interrupt mode.
Set desired copier functions or output tray
destination and press Start. Copying begins and
paper is output to the selected tray.
When done copying in interrupt mode, turn off
interrupt copy mode from the machine itself.
Replace the original and press Start. Copying of
the interrupted job resumes.