Connecting Wires to Terminals
KDC-MP2028
A Front left output (White)/
Front right output (Red)
B To KENWOOD disc
changer/ External
optional accessory
To connect these leads, refer to the
relevant instruction manuals.
If no connections are made, do not let the wire come out from the tab.
Connect either to the power control
terminal when using the optional power
amplifier, or to the antenna control terminal
in the vehicle.
Connect to the terminal that is grounded
when either the telephone rings or during
conversation.
To connect the KENWOOD navigation system,
consult your navigation manual.
Do not let the wire come out from
the tab.
To front right speaker
Ignition key switch
Car fuse box
(Main fuse)
Battery
+
KDC-MP228/228
—
To KENWOOD disc
changer/ External
optional accessory
Fuse (10A)
White/Black
To front left speaker
White
Gray/Black
Gray
Green/Black
To rear left speaker
Green
Purple/Black
To rear right speaker
Purple
Car fuse box
–
Rear left output (White)/
Rear right output (Red)
B
Power control/Motor antenna
control wire (Blue/White)
P.CONT
TEL mute wire (Brown)
MUTE
Not Used (Blue)
ANT.
CONT
ACC
Ground wire (Black) - (To car chassis)
FM/AM antenna input
Wiring harness
(Accessory1)
FRONT L
FRONT R
REAR L
REAR R
Ignition wire (Red)
Battery wire (Yellow)
English
A
25
|