Hendi 272411 Mode D'emploi page 8

Lightling instructions
Before first use and after every gas cylinder
change, gas delivery system must be purged of air
before igniting! To do this, turn the control knob an-
ticlockwise to the pilot setting. Press knob in and
hold for 3 minutes before attempting ignition.
• Check all gas connections prior to use.
• Turn on gas supply at source.
• Press to turn control knob anticlockwise to 'IGNI-
TITION (PILOT)'.
• Hold knob depressed until pilot flame is lit, then
continue to hold the knob depressed for 20 sec-
onds until the pilot remains lit after releasing
knob.
• If pilot fails to ignite or remain alight, press to
turn knob clockwise to 'OFF' and repeat.
• The pilot should be lit & the knob set to 'PILOT'.
• Hold knob depressed gently & turn anticlockwise
to 'LOW' or "HIGH" as desired.
Maintenance & servicing
To enjoy years of outstanding performance from
your heater, make sure you perform the following
maintenance activities on a regular basis:
EN
• Keep exterior surfaces clean.
• Use warm soapy water for cleaning. Never use
flammable or corrosive cleaning agents.
• While washing your unit, be sure to keep the area
around the burner and pilot assembly dry at all
times. If the gas control is exposed to water in
any way, DO NOT try to use it. It must be replaced.
• Airflow must be unobstructed. Keep controls,
burner and circulation air passageways clean.
Signs of possible blockage include:
- Gas odor with extreme yellow tipping of flame.
- Heater does NOT reach the desired temper-
ature.
Servicing
• Please consult your local dealer for servicing this
appliance and replacement of its parts. The ser-
vicing of the appliance shall be carried out only by
authorised personnel.
8
To Entinguish
• Hold knob despressed & turn the knob clockwise
to "OFF".
• Close the valve of the gas cylinder or the regula-
tor after use.
• Allow this appliance to cool before moving.
- Heater glow is excessively uneven.
- Heater makes popping noises.
• Spiders and insects can nest in burner or orifices.
This dangerous condition can damage the heater
and render it unsafe for use. Clean burner holes
by using a heavy duty pipe cleaner. Compressed
air may help clear away smaller particles.
• Carbon deposits may create a fire hazard. If any
carbon deposits develop, clean dome and engine
with warm soapy water.
Note: in a salt-air environment (such as near the
sea), corrosion occurs more quickly than normal.
Frequently check the corroded areas and repair
them promptly.
• Caution: do not use unauthorized parts or com-
ponents for this appliance, only use original
equipment replacement parts and components.
The use of unauthorized parts or components
will void the warranty and can create an unsafe
condition.