Setup 3: Connect The Audio Cord; Setup 4: Connect The Power Cord - Sony SDM-X202 Mode D'emploi

2 Using the supplied HD15-HD15 video signal cable
(analog RGB), connect the computer to the
monitor's HD 15 input connector (analog RGB) for
INPUT 1 or INPUT2.
Connect the computer according to the following
illustrations.
xConnecting to an IBM PC/AT or
compatible computer
to the HD 15 input
connector (analog RGB)
for INPUT1 or INPUT2
to the computer's HD15 output
connector (analog RGB)
IBM PC/AT or
compatible computer
xConnecting to a Macintosh
to the HD 15 input
connector (analog RGB)
for INPUT1 or INPUT2
to the computer's output
connector
Macintosh
When connecting a Macintosh computer, use an adapter (not supplied),
if necessary. Connect the adapter to the computer before connecting the
video signal cable.
8
HD15-HD15 video signal
cable (analog RGB)
(supplied)
HD15-HD15 video signal
cable (analog RGB)
(supplied)

Setup 3: Connect the audio cord

Connect the supplied audio cord to the monitor's
corresponding audio input jack.
Using the monitor's speakers or headphones, you can listen to
sound from your computer or other audio equipment connected to
the monitor's audio input jacks.
For more information, see "Controlling the volume" on page 18.
to the audio input for
INPUT1 or INPUT2
to audio output of the
computer or other
audio equipment

Setup 4: Connect the power cord

1 Connect the supplied power cord to the monitor's
AC IN connector.
2 Connect it to a power outlet.
to AC IN
to power outlet
power cord (supplied)
2
audio cord (supplied)
1