Publicité
Les langues disponibles
Les langues disponibles
BMH 1000
Application
The Pneumatic Drill Hammer can be used universally
for impact drilling, for light chiselling work in masonry
and for drilling as well as screwdriving in wood, metal
and plastic.
Safety Instructions and
1
Accident Prevention
Before putting the machine into operation, read
through these operating instructions completely and
observe the safety instructions contained therein as
well as those in the enclosed booklet on general
safety instructions for electro-tools.
If the mains cable is damaged while working, pull
the mains plug immediately.
Never work with a damaged mains cable.
Wear protective glasses, hearing protection, pro-
tective gloves and sturdy shoes.
Wear hearing protection. Exposure to noise
can cause hearing loss.
Use the auxiliary handles supplied with the
machine. Loss of control can cause personal
Do not work with materials containing asbestos.
Do not carry the machine by the cable.
The mains receptacles in the working area must be
protected by a residual current circuit breaker (RC).
For the attachment of identification markings on the
machine, do not drill into the housing. The protec-
tive insulation would be shorted. Use stickers.
When the drill unexpectedly jams, the machine
kicks back. Therefore, always take a secure stance
and hold the machine firmly with both hands.
2
Illustration
1 Tool holder
2 Dust protection cap
3 Unlocking collar
4 Gear selector/Rotation stop switch
5 Ventilation slots
6 Rotational direction switch
7 Locking button for on/off switch
8 On/Off switch
9 Speed selection knob
10 Drilling/Impact drilling selector
11 Holder for depth stop
12 Auxiliary handle
13 Latch for mains cable module
14 Adapter for screwdriver bits/drill chuck
Accessories illustrated or described are not
always included as standard delivery items.
3
Technical Data
Pneumatic Drill
Hammer
Article number
Input power
Output power
Electronic control
Full wave electronic
No-load speed
1st Gear
2nd Gear
Speed under load
1st Gear max.
2nd Gear max.
No-load impact rate
Load hammer blows
Right/Left rotation
Clamping collar dia.
Tool holder
Drill dia., max.
Steel
Light metal
Wood
Hammer drilling in
conctrete
Recommended
hammer drilling
range
Screw dia., max.
Wood
Sheet metal
Corner measure
Weight
Protection class
4
Noise/vibration information
Measured values determined according to
EN 60 745.
Typically the A-weighted noise levels of the machine
are: sound pressure level 96 dB (A); sound power level
107 dB (A). Measurement uncertainty
K = 3 dB.
Wear hearing protection!
The typically weighted acceleration is 7,8 m/s².
English
BMH 1000
0428 3512
1000 W
600 W
•
•
125-875 RPM
250-2000 RPM
800 RPM
1850 RPM
4700/min max.
4300/min
•
43 mm
Euro standard
SDS-Plus
16 mm
25 mm
50 mm
28 mm
4-16 mm
8 mm
6.3 mm
42 mm
2.8 kg
II/
7
Publicité
