Haier HWE15XCN Guide D'utilisation Et D'entretien page 19

PREPARING THE AIR CONDITIONER: HWE24VCN
1. Measure the width of the window opening. (See Fig.22)
2. M a k r the center line on the inside of the windowsill
with a pencil. (See Fig.23)
WIDTH OF
WINDOW OPENING
Fig. 22
NOTES AND WARNINGS:
• Be sure your air conditioner does not fall out of the opening during installation or removal.
• A grounded electrical outlet within 4 ft. (122 cm) of where the power supply cord exits the air
conditioner.
• Do not block the air discharge or air intake areas on the front panel.
• Do not block the louvers on the outside of the air conditioner.
INSTALL THE CABINET IN THE WINDOW
FOR MODEL HWE24VCN (See Fig.24)
1. Center the cabinet in the windowsill. Make sure to place the unit so that it is resting on the
windowsill with a ¼" to ½" downward tilt towards the outside. Lower the window sash behind
the front flange of the top channel to hold the unit in place. The bottom channel must rest
behind the window sill. (See Fig.24)
NOTE: The appearance of your model may differ from the one shown.
WIDTH
Fig. 24
HOW TO INSTALL
CENTER LINE
Fig. 23
Bottom Channel
Window Sill
ENGLISH
CENTER
PAGE 17