Completing The Installation - Haier HWE15XCN Guide D'utilisation Et D'entretien

COMPLETING THE INSTALLATION: HWE15XCN/HWE18VCN
COMPLETE THE INSTALLATION
1. Uncoil the included foam seal. (See Fig.15)
2. Insert the foam seal behind the top of the lower window sash and
against the glass of the upper window. (See Fig.16)
A. Top of lower window sash
B. Foam seal
3. Place the window lock bracket as shown. Use
one(1) 1⁄8" drill bit to drill a starter hole through
the hole in the window lock bracket and into the
upper window sash. (See Fig.17)
4. Attach the window lock bracket to the upper
window with one (1) 1" wood screw to secure
the window in place. (See Fig.17)
INSTALLING THE CHASSIS TO THE CABINET
When moving or lifting the air conditioner chassis, use
two or more people. Wear gloves when handling the air
conditioner to protect against possible sharp edges and
metal fins.
1. Pick up the chassis carefully and evenly.
2. Slide the chassis into the cabinet. (See Fig.18)
3. Reinstall the front panel.
4. Secure the front panel to the chassis using the screws
removed at the start of the installation. (A) (See Fig.19)
5. Reinstall two of the screws removed from the cabinet at the start of the installation. (B) (See
Fig.19)
6. Plug the unit in. Press RESET on the power supply cord. A green light will come on. See
"Electrical Requirements."
Fig. 18
(A) Top of lower
window sash
(See Fig.18)
Fig. 17
Window Lock
Fig. 19
B
HOW TO INSTALL
Fig. 15
(B)Foam seal
Bracket
A
B
ENGLISH
Fig. 16
B
PAGE 15