S&P TERMOTECH - 1250 Manuel D'installation page 11

The accessories needed for assembly can be found inside the
packaging (4 support hooks and their 4 screws).
Do not leave packaging within the reach of children and recycle it in
agreement with the by-laws in force.
Ensure that the voltage supply coincides with that indicated on the
characteristics´ plate of the appliance.
For connection to the electrical supply use a
power cable.
Do not position the supply cable with a curvature radius of less
than 50 mm.
The heating appliance must not be placed directly below a power socket
and must not be installed inside the bathroom.
Place the appliance at a minimum height of 3 m, leaving at least, 5 cm between
the heater and the ceiling
This product must not be used by persons (including children) with
physical, sensorial or mental disabilities or without sufficient knowledge or
experience, if they are not under the supervision of a responsible and suitably
instructed person. Children must be supervised to ensure they do not play with
the product.
Do not touch to the appliance with wet hands or wet feet and do not
stretch the power cable.
The connection of the appliance to the mains must be provided
with a bipolar switch with a minimum contact opening of 3mm and must
be in compliance with the standards in force in the country where it is to be
installed.
The radiant frontal surface of the panel must remain free and
uncovered by objects as these may damage it beyond repair and provoke a fire.
It is therefore indispensable that these safety warnings are
11
H05VV-F 3 G 1mm
2