Timbertech STAN01 Mode D'emploi page 37

1. Power input connection
Power input (X1): L (live), N (neutral) (AC220 V)
The gate operator must be grounded.
You will find the earth connector is located on the base plate.
2. Infrared sensor connection
Then connect the infrared sensor receiver to the knot 24VDC,
GND and I.R. in terminal X5 (see Fig. 9).
3. Verify the opening direction
If the gate does not move in the desired direction, then you will need to reverse the motor
operating direction by exchanging wires 'U' and 'W', 'OPLM' and 'CLLM'.
4. Caution light connection
Connect the caution light wire to D1 and D2 in terminal X3.
5. Single-button switch / Three-button switch connection
(not included in the delivery)
Single-button switch (Fig. 11)
Connect the single-button switch to 'CLS'
of terminal X7 and the other to the 'COM'.
The single button switch will function
in single channel mode (one switch for
opening, stop and closing)
Warning: The DIP switch
1 should be turned off
when you use a single
button switch.
Three-button switch (Fig. 12)
Connect the open wire of the three-
button switch to 'OPN', the close wire of
the switch to 'CLS', the stop wire of the
switch to 'STP', and the common wire of
the switch to 'COM'.
Warning: The DIP switch
1 should be switched on
when you use a three-
button switch.
DE FR EN ES EN
(not included in the delivery)
ON
1 2 3
Single-button switch
ON
1 2 3
Three-button switch
37
Terminal X7
Keypad
Control board
terminal block
Terminal X7
Open
Close
Stop
Common
Control board
terminal block
Fig. 11
Fig. 12