Activation Of Personal Cards; Deactivation Of Personal Cards - Fermax LOFT Manuel D'utilisation

Activation of personal cards

A total of up to 400 cards may be activated, following these steps:
¡Beep!
1. Show the MASTER
card. The indicators
will display "activate
card mode."".
A "beep" indicates that the card has been correctly activated. If not, indicates
card had been activated previously, or that the card is faulty.
Annotate the number ef each card for future references.
If you try to activate more than 400 cards, the system will indicate "overload"
( "+" indicator blinking for 5 seconds).

Deactivation of personal cards

To deactivate cards in the system they must be physically available. The procedure is
as follows:
¡Beep!
¡Beep!
1. Show the MASTER card
(twice).
The indicators will dis-
play "deactivate card
mode."
To deactivate cards without having them available see note.
NOTE:
It is also possible to program cards (and delete) by means of the PROGRAMMING
KEYPAD REF 2306 or by means of a PC and the WINPROX program developed by
FERMAX.
CONTACT YOUR NEAREST DISTRIBUTOR FOR FURTHER DETAILS.
Pag 6
¡Beep!
2. Show the cards to be activated
one at a time.
¡Beep!
2. Show the cards to be deactivated one
at a time.
One "beep" indacates that the card
has been deactivated, If not it means
that the card was not activated.
¡Beep!
3. Show the MASTER card
at the end, until the
indicators display "normal
mode."
¡Beep!
3. Again show the MASTER
card at the end, until
indicators display "normal
mode."
¡Beep!
¡Beep!
¡Beep!
¡Beep!
t h a t
¡Beep!
¡Beep!
¡Beep!