Eazyzap CT870 Mode D'emploi page 3

• The appliance is not to be
used in locations where
flammable vapour or
explosive dust is likely to
exist.
• Do not use in barns , stables
and similar locations.
• EAZYZAP recommend that
this product is connected
to a circuit protected by an
appropriate RCD (Residual
Current Device).
Introduction
Please take a few moments to carefully read
through this manual. Correct maintenance and
operation of this machine will provide the best
possible performance from your EAZYZAP product.
Pack Contents
The following is included:
• EAZYZAP Glue Trap
• Detachable power cord
• Instruction manual
EAZYZAP prides itself on quality and service,
ensuring that at the time of packaging the contents
are supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your EAZYZAP dealer immediately.
Installation
1. Remove all packaging and protective film from
the appliance.
2. For best results, locate the appliance in the
darkest part of the room, but at least 1 metre
away from food preparation areas.
Note: Close proximity to other light sources
such as sky lights and windows will reduce
the effectiveness of the appliance.
Prepare the mounting fixings (not supplied)
before installation. If in doubt seek
professional advice or assistance.
CT870_ML_A5_v3_20201119.indb 3 CT870_ML_A5_v3_20201119.indb 3
3. Upon necessity you can install the appliance
onto the wall as instructed below.
1
• Drill 2 holes on the wall. Ensure there is no
electric/water pipe beneath the holes.
• Insert wall plugs and screws into the holes
consecutively (Fig. 1).
2
• Hang the appliance on the screws and ensure
it rests in place (Fig. 2).
UK
3
2020/11/19 15:19 2020/11/19 15:19